Kramer Electronics VS-88FO - Manual (Page 28)

VS-88FO - Operating the VS-88FO 25
6.1.9 Switching Protocols
You can operate the VS-88FO using either the KRAMER 2000 or the default
KRAMER 3000 serial protocol.

To choose the Kramer 2000 protocol instead of the default Protocol 3000,
press OUT 1 and OUT 2 at the same time.
OUT 1 flashes briefly if the change was made correctly

To revert to the Kramer 3000 protocol, press OUT 1 and OUT 3 at the same
time.
OUT 1 flashes briefly if the change was made correctly
If an error is indicated, retry the previous action or choose a new action.
6.2 Using Serial Commands
To operate the VS-88FO using serial commands, Kramer provides free control
software that you can download from the Kramer Electronics Web site.

For an explanation of all KRAMER 3000 commands, see Section 9

For an explanation of all KRAMER 2000 commands, see Section 10
6.3 Using the Infrared Remote Controller
To operate the VS-88FO using the RC-IR3 infrared remote controller, see the User
Manual packed with the remote controller.
See also the Kramer Web site: www.kramerelectronics.com.
Note:

You cannot change genlock timing from the remote control, only from the
front panel.

The IR remote controls only 8 preset configurations equivalent to OUT 1 to
OUT 8