Fagor 6H-54X - Manual (Page 33)

e n g l i s h
31
5
The Environment
4
Troubleshooting
You can solve the following problems yourself:
4.1 The oven is not heating up. Check it is plugged in and
switched on and that the fuse has not blown. Select a
higher temperature setting.
4.2 The interior light is not working. Change the bulb or
replace the fuse.
4.3 Smoke is coming out during cooking. Turn the
temperature down and/or clean the oven.
4.4 The pyrolysis cleaning process is not being carried
out. Ensure the door is correctly closed. Locking system
or temperature sensor failure. Call the Technical Service.
4.5 A beep is sounding. The selected temperature setting
has been reached. The cooking cycle is complete.
4.6 The oven makes a noise after cooking. This is normal,
as the fan keeps running until the temperature inside
and outside the oven is reduced.
4.7 Failure warnings.
Temperature sensor failure.
Door blocked (4.7.1).
Pyrolysis cannot be carried out.
Door block failure.
Software Failure.
Power cut during cooking.
The oven automatically switches off as it has
been functioning for several hours (4.7.2).
Do not try to repair the oven yourself. Call the
technical assistance service.
4.8 Demo Function: Set the time to ‘0:00’. When the oven
is OFF, press timer touch. In the display you will see the
timer and ‘Demo’ blinking. To deactivate it switch off the
oven.
This oven has been designed with environmental
protection in mind.
Respect the environment. Only preheat the oven
when necessary (see table). Use dark coloured cake tins
whenever possible. For long cooking times, switch off the
oven 5 or 10 minutes before the end of cooking time.
Management of waste electrical and electronic
equipment.
The symbol indicates that the appliance must not be
disposed of in traditional bins for domestic waste.
Take your oven to the a special collection centre.
Recycling domestic appliances will prevent negative
consequences for health and the environment and will
allow savings on energy and resources.
For further information, contact the local authorities or the
shop where you bought the oven.
When the oven has cooled down, open the door as
wide as possible (3.7.1) and fi x it in place with the red
stop supplied in the accessories bag (3.7.2). Use the
remaining sheet accessory on one side of the glass to
raise up the glass like a lever. Do the same on the other
side of the glass. Remove the red stop and close the
door (3.7.3). Remove the glass (3.7.4), clean it and dry it
with a cloth (3.7.5). If necessary, remove the whole glass
panel unit inside the door. This unit consists of either one
or two glass panels, depending on the model, with a black
stop in each corner. To remove them, place your hand
under the door and pull upwards (3.7.6). When you have
taken out the unit, remove the stops to clean the glass
panels (3.7.7).
When the glass panels are clean (3.7.8) fi t them onto the
rubber stops again, with the stud facing upwards (3.7.9)
and replace the glass panels so that the letters “L” (left)
and “R” (right) are beside the hinges (3.7.10). Lastly, place
the remaining glass panel so that the word PYROLYTIC
can be read (3.7.11). Remove the stops (3.7.12) and close
the door.
Warnings:
• Make sure the oven is switched off.
• Allow the glass to cool down before removing it.
• Never use steam cleaning machines.
3.8 Cleaning the outside of the oven: Use neutral cleaning
products. Dry the oven well with a soft cloth.
3.9 The AquaSliding Function system makes it easier to
clean the oven with steam. It takes 35 minutes and is
done as follows:
• Start with a lukewarm oven.
• Remove all accessories and side guides from the
model.
• Spray 200 ml of water onto the inside walls of
the oven. Using too much water could cause
overfl ow.
• Depending on the model,
a) AquaSliding wait until the oven indicates the end
of the cleaning cycle.
b) traditional t 150ºC for 10 minutes. After this
time has elapsed, reduce the temperature to
minimum (35ºC - 75ºC according to the model)
and maintain for 25 minutes. Failure to follow
these instructions may cause condensation on
the front.
• Switch the oven off.
• Carefully open the oven door, avoiding contact with
the steam.
• At the end of the cycle, remove the water from inside
and wipe away any remaining dirt with a dishcloth.
This cycle is used to assist cleaning but loses its
effectiveness if the recommended times are not
followed.
* Depending on the model, it can assist the Warning
function.