Power Soak 27173 Chemical Dispenser Installation Guide - Manual (Page 7)

7
Priming the Feed and Discharge Lines
After both pump timers have been set, close and lock the door to the dis-
penser enclosure and locate the “prime” buttons for the Wash Detergent and
Sanitizer pumps. The prime buttons are located under the enclosure on the
left-hand side (Detergent) and right-hand side (Sanitizer). Press and hold the
left prime button until the Detergent flows from the Wash Tank injector noz-
zle. Press and hold the right prime button until Sanitizer flows from the Sani-
tizer Tank injector nozzle.
Note: after priming both lines be sure to clean up any excess detergent or
sanitizer remaining in the tanks.
The installation of the dual dispenser pump is now complete.
If you have any questions concerning the
installation of the dispensing sys-
tem, please call the Metcraft, Inc. Service Department @ 816-761-3250.
If you have any questions concerning the operation of the dispensing system,
please call Kay Chemical Customer Service @ 800-529-5458.