Power Soak 27173 Chemical Dispenser Installation Guide - Manual (Page 3)

3
Installation of the Pump Feed and Discharge Tubes
Step #1
Run a piece of “clear” plastic tubing (the Feed
Tube), provided with the installation kit, from the
detergent bag holder to the dispenser pump. If
necessary, use the support loops located under
the unit’s sinks to hang the tubing. Cut the deter-
gent Feed Tube to the proper length and connect it
to the barbed fitting on the left, “Wash Detergent”,
pump.
Tube support loop
Step #2
Run a piece of “clear” plastic tubing (the Feed Tube), provided with the in-
stallation kit, from the sanitizer supply. Cut the sanitizer Feed Tube to the
proper length and connect it to the barbed fitting on the right, “Sanitizer”,
pump.
Step #3
Secure both lines to the barbed fittings using plastic wire ties. To ensure the
tubing is secure, pull the tie wraps tight using a pair of pliers. Cut off the ex-
tra portion of the tie wraps.
Step #4
Use the “white” (opaque) plastic
tubing provided with the installa-
tion kit for both the Wash Tank
and Sanitizer Tank discharge
tubes. Run the tubes from the
injector nozzles, located in the
sides of the tanks, to the appro-
priate pumps. Cut the tubes to
the correct length and connect
the tubes between the injector
nozzle and the “discharge” side
of the appropriate dispenser
pump using the supplied com-
pression fittings.
Detergent feed tube
Detergent discharge tube
Sanitizer feed tube
Sanitizer discharge tube