ACTiSYS PP2-5600 - Manual (Page 37)

Infrared Modem User’s Manual
Page 37 of 41 Revision 1.0 2003/11 From 3JTech
Appendix A_Windows98 IR setup(R220L/210L/200L)
This section describes how to use 3JTech’s PP2I infrared modem with ACTiSYS’s
IrDA dungo, which includes ACT-IR220L/210L/200L are IrDA dungos for converting
RS232C to an infrared port.
Caution: To install this SIR driver in Windows98, please be sure no FIR driver
was installed first. If the FIR driver was already installed, even you remove this
FIR driver and then install SIR driver, it may not work properly.
*Do not install Infrared Driver Ver 2.0 under Windows98, it will not work at all.
Connect ACT-IR2xxL serial adapter to the Com port of desktop PC. If there is no IR
window on the portable PC, another IR2xxL should be connected to the portable PC.
1. Go to “Control Panel” and double
click on “Add New Hardware”.
2. On the following screens, click on
“Next” twice, then select “No, the
device isn’t in the list”. And click on
“next”.
3. Select “No I want to select
Hardware from the list”,
4. Scroll down the menu and
highlight “Infrared Devices”,
then click on “Next” twice.
5. Under “Manufacturers” Select