AGFA TM 14ADV - Manual (Page 134)

User’s Manual 6-15
SOLVING
PROBLEMS
Error Indications
Message Causes and solutions
MOTOR FAILURE n Cause: Malfunction in the feed motor,
etc.
Solution: If the error recurs, consult
your dealer for service.
NO PROCESS UNIT Cause: No print unit is installed.
Solution: Install the print unit.
OVERRUN ERROR Cause: Incomplete in extracting
compressed data
Solution: Press the
button.
PAPER JAMn Cause: Paper jam in the specified
position
Solution: Clear the jammed paper from
the following area:
0: Pick roller, 1: Entry to paper path
2: Paper path, 3: Ejection from paper
path
4: Duplex unit
PS ERROR mn Cause: A PostScript error
Solution: If the error recurs, consult
your dealer for service.
Source PAPER OUT Cause: Paper out in the specified paper
source
Solution: Supply paper.
STACKER FULL Cause: Paper stacker full
Solution: Remove paper from the paper
stacker.
SYSTEM ERROR n Cause: A system error on the controller
board
Solution: If the error recurs, consult
your dealer for service.
TRAYn MISS SET Cause: Paper tray installed incorrectly
Solution: Install the paper tray.
TONER EMPTY Cause: Toner runs out.
Solution: Replace toner bottle and heat
roller cleaner.
08 Chapter 6 07.08.1997, 11:41 Uhr 15