AccuTemp EVOLUTION GAS STEAMER - Manual (Page 23)

MP4010-1003 EVOLUTION GAS STEAMER
17
DAILY PREPARATION FOR USE - CONNECTED MODELS
Preparing the Evolution Connected model for use each day requires very little time
and effort. Simply verify that the steamer is clean, the water line to the steamer is
turned on and the drain valve is in the closed position. Close the door and push the
ON/Off key on the keypad. The steamer will automatically fill and preheat.
Since the Evolution automatically senses the water level and refills as required.
there is no need to manually fill the steamer.
PREHEATING ( Fig.12)
1) Depress the On/Off Key to turn on the steamer. The display will indicate PrE while
in Cook Mode and the temperature while in the hold Mode.
2) Once the steamer is preheated and ready to cook, the display will indicate the
COO (Cook Mode) or hLd (hold Mode).
3) Depress the DISP TEMP button to display the current cooking temperature.
COOKING ( Fig. 13)
1) Depress the COOK/hOLD button to select the Cook Mode (COO).
2) Open the door and place food into the cooking chamber. Shut the door.
Cooking begins immediately.
3) Timer — Depress the TIMER button and depress the ARROW keys [▲ or ▼] until
the desired time is displayed. The timer starts automatically. At the end of the timed
cycle, a beeper will sound.
4) Depress the DISP TEMP button to display the current cooking chamber
temperature.
HOLDING (Fig. 14)
In “hold” the steamer temperature is set for 180° F from the factory. The hold
temperature can be changed to a single value for temperatures ranging from
150°F to 190°F if required. Contact the AccuTemp Technical Service Department
for assistance at 800.480.0415 or 260.469.3040. hold can also be used during
downtimes to save energy and water while keeping the steamer preheated.
1) Depress the COOK/hOLD button to select the hold Mode (hLd).
2) Open the door and place food into the cooking chamber. Shut the door.
3) Food will be held at the preset holding temperature. The factory setting is set at
180° F.
4) Depress the DISP TEMP button to display the current cooking chamber
temperature.
OPerAtiOn
Fig. 12
Fig. 13
Fig. 14