A.J. Antunes & Co WD-50 9400167 - Manual (Page 8)

WARMER DRAWER
8 P/N 1011027 Rev. E 05/10
WARNING
Turn the power off, unplug the power cord, and allow
the unit to cool down before performing any service or
maintenance.
MAINTENANCE
Cleaning
DAILY
1. Turn the power off, unplug the power cord, and
allow the unit to cool down.
2. Remove all parts from inside the Warmer Drawer.
Wash all parts in soap and water, rinse in clear
water, and wipe dry.
3. Wipe the exterior of unit with a damp cloth or
stainless steel cleaner, then wipe dry with a
clean, dry cloth.
4. Re-install all parts into Warmer Drawer.
NOTE: Failure to properly clean and dry the parts
prior to reassembly may result in the accumula-
tion of water/moisture overnight. This may lead to
permanent damage of the equipment finish and its
accessories that is not covered by the warranty.
CAUTION
To prevent damage to the unit, do NOT use abrasive
cleaners on the unit.
WARNING
Use caution when using caustic cleaning solutions.
Read all manufacturer label instructions to avoid per-
sonal injury.
Figure 4. Removing Drawer
WEEKLY
1. Turn the power off, unplug the power cord, and
allow the unit to cool down.
2. Remove all parts from the Warmer Drawer. Wash
all parts in soap and water, rinse in clear water,
and wipe dry.
3. Pull the Drawer out by pushing down simultane-
ously on both interlocking tabs and then pulling
the Drawer away from unit (Figure 4).
4. Wipe the interior of the Warmer Drawer with a
clean, damp cloth.
5. Wipe dry the interior of the Warmer Drawer with a
clean, dry cloth.
6. Wipe the exterior of unit with a damp cloth or
stainless steel cleaner, then wipe dry with a clean,
dry cloth.
7. Re-install all parts into unit and plug in the power
cord.
Drawer
Interlocking Tab