Media Technology Systems ION8.8 User Manual
Page 18
Page 18 of 31
Aug‐09
•
Set
the
ION
Ethernet
port
to
192.168.192.100
(say).
This
is
done
via
the
VFD
–
see
section
below.
•
Go to Control Panel and then open “Network connections”.
•
Click on the General tab and open “Properties”.
•
Select “Internet Protocol (TCP/IP)” and click on properties.
•
Finally,
change
the
selection
from
“Obtain
an
IP
address
automatically”
to
“Use
the
following
IP
address”
and
set
as
follows:‐
•
IP address: 192.168.192.50
•
Subnet
mask:
255.255.255.0
It
can
be
any
IP
address
in
the
range
192.168.192.2
to
192.168.192.99.
Once
the IP address and subnet mask has been set then open the GUI application.
•
After
finishing
using
the
MTS
GUI
application,
return
to
the
Control
Panel
and
reset
the
selection
back
to
“Obtain
an
IP
address
automatically”.
If
an
intelligent
or
managed
switch/router
is
in
use,
then
the
switch
address
will
need
to
be
set
to
the
same
subnet,
usually
192.168.1.1
or
192.168.1.254
are
the
most
common
default addresses.
4.2.1 GUI default page
The
GUI
application
default
page
is
shown
below
in
Figure 4-2.
Figure 4-2:
GUI opening page