AVE MV DR4000 - Manual (Page 22)

20
4.2.3 Alarm / Motion Recording
Take the following steps to activate the programmed alarm recording. For ALM OPERATION ,
REC RATE , REC QUALITY , AUDIO , ALM TYPE , ALM DURATION , and PRE-ALARM settings,
please refer to section 5.2 for more details.
(1) Press the Setup button to enter the MAIN MENU .
(2) Select ALARM/ MOTION and press the Enter button to enter the ALARM/ MOTION
SETTING .
(3) Set the desired REC RATE, REC QUALITY, ALM TYPE, and ALM DURATION for use. If
audio is required, set AUDIO to ON . If pre-alarm recording is required, set PRE-ALARM to
ON .
(4) To activate the alarm recording, set ALM OPERATION to ON . To deactivate it, set ALM
OPERATION to OFF .
(5) To active the motion alarm recording, Select MOTION SETTING and press the Enter button
to enter the MOTION SETTING PAGE, set CH1/ CH2/ CH3/ CH4 TO ON, and set a suitable
sensitivity according to the video sources. 1 is the Highest sensitivity, 5 is the lowest.
MAIN MENU
RECORD
ALARM
TIMER/ SEQ/ TITLE
COMMUNICATION
DISK
SYSTEM
GOTO ALARM/ MOTION PAGE
ALARM / MOTION
ALM OPERATION : ON
REC RATE
: 10F/S
REC QUALITY : BEST
AUDIO : OFF
ALM TYPE : NO
ALM DURATION : 0 SEC
PRE- ALARM : OFF
MOTION SETTING
MAIN PAGE
ALARM REC ENABLE
ALARM / MOTION
ALM OPERATION : ON
REC RATE
: 20F/S
REC QUALITY : BEST
AUDIO : OFF
ALM TYPE : NO
ALM DURATION : 0 SEC
PRE- ALARM : OFF
MOTION SETTING
MAIN PAGE
ALARM REC ENABLE
MOTION SETTING
CH1
: ON
CH2 : OFF
CH3 : OFF
CH4 : OFF
SENSITIVITY : 3
MAIN PAGE
SET MOTION DETECTION