Bosch NETP666SUC - Manual (Page 10)

10
Heating elements
Residual heat indicator
The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
If an
• is shown on the display, the element is still hot.
You could use it, for example, to keep a small quantity of
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to œ . The display
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.
Operation
Main power switch
Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the symbols $ for the heating elements
turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
10 seconds.
If residual heat is still present when the cooktop is turned
on, • / œ will appear in the heating element display.
Main power switch
Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the symbols $ for the heating elements
turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
15 seconds.
If residual heat is still present when the cooktop is turned
on, • / œ will appear in the heating element display.
Element Turning on and off
$ Single element Always use cookware of a suitable size.
ð Dual element The size of these elements can be matched to your pan size. The heating element must
be turned on.
Turning off the outer heating ring: Touch
ö . The ð display will turn off.
Adding: Touch ö again. The ð display will turn on.
ò Triple element
(NETP666SUC only)
On this element you can turn the medium and large heating rings off. The heating
element must be turned on.
Turning off the outer heating ring: Touch
ö . The ò display will turn off.
Turning off the middle heating ring: Touch ö again. The ð display will turn off.
When you turn the heating element on again, all of the heating rings will be on.
à Bridge element
(NETP666SUC only)
The Bridge element combines two individual heating elements into one long griddle zone.
This configuration is ideal for griddles and large pans.
Note: : Do not use cookware larger than 17" x 10" (432 x 254 mm).
Turning on the Bridge element: Touch one of the two
$ touch keys for selecting the
heating element, then touch the à key. The à symbol will appear; both heating elements
are now selected. ‹ appears in both displays. Within the next 10 seconds select the
desired heat setting (1-9). The Bridge element and both individual heating elements are
now on.
Changing the heat setting: Touch one of the two
$ touch keys for
selecting the Bridge element, and set the new heat level within the next 10 seconds.
Turning off the Bridge element feature: Touch one of the two
$ touch keys for selecting
the Bridge element, and select 0 from the number keys. ‹ appears in both displays. The
heating elements will turn off and the residual heat indicator will appear.