In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 28)

28 Optional Battery Box
6.4 CONNECT THE EXTERNAL BATTERY ENCLOSURE TO THE
CON TROLL PRO ENCLOSURE
1. Route the cable from the External Battery Enclosure to the Con TROLL
PRO enclosure.
2. Thread the cable through the dome connector and into the enclosure.
3. Connect the leads to the PLC inputs in the I/O Board as described in the
Con TROLL PRO Installation manual in Section 5.1 PLC Connections, on
page 24.
4. Thread the opposite end of the cable through the dome connector and
into the battery enclosure.
5. Firmly tighten the dome connector with a wrench.
6.5 CONNECT THE BATTERY TERMINALS
1. Place the batteries in the enclosure as shown.
2. Connect the black (–) leads to the black terminals.
3. Connect the red (+) leads to the red terminals.
Upon connection of the red leads, you should notice that the Con TROLL
PRO screen illuminates.
FIGURE 22. Internal components of the battery box
Batteries with leads attached
Charge controller
Terminal block