Use of equipment, Installation, Operation – Hired-Hand RollSeal Rollup Curtains: Ridder Motor Control User Manual
Page 4: Wiring diagrams, schematics, etc, 1 tools required, 2 instructions, 1 power supply to ridder controller
4801-5081
Ridder Motor Control
2
4. Use of Equipment
This Controller is designed to use as a driver for Ridder motors. It is set up to only be used with
the motors listed in the rating and specification part above. These motors are used in ways such as Rollseal
curtains and green house roof system.
5. Installation
5.1 Tools Required
Electric Drill, Phillips Screwdriver, Standard Screwdriver, Mini Screwdriver, WireStrippers
5.2 Instructions
1. Hang controller using four screws.
2. Drill holes in box for using elliots or conduit.
Warning: All holes must be to the right half of controller in bottom of controller.
3. Connect Power Supply to controller using diagram 7.1.
4. Connect motor and limit switches using diagram 7.2.
5. Connect automatic control source using diagrams 7.3 - 7.6.
6. Set limits on motor.
6. Operation
When controller is in manual position motor will operate off of Open /Close switch. When flipped
to Auto the controller works off of external control source such as a thermostat or electronic controller.
7. Wiring Diagrams, Schematics, etc.
7.1 Power Supply to Ridder Controller
1
GND
9
12
10
8
7
6
5
4
3
2
11 12 13 14 15 16 17 18
L1
L2
HO
T
OP
E
N
CLO
SE
GND
U1
W2
V1
U2
W1
1
3
7
9
4
CONTROL MOTOR RIDDER RW245
OUT
P O W E R
240V
SWITCH
CLOSED
SWITCH SWITCH
OPEN
SAFETY
V1
W2
3
1
9
7
TO REVERSE
1
GND
9
12
10
8
7
6
5
4
3
2
11 12 13 14 15 16 17 18
L1
L2
HOT
OP
E
N
CLO
SE
GND
U1
W2
V1
U2
W1
1
3
7
9
4
CONTROL MOTOR RIDDER RW245
OUT
P O W E R
240V
SWITCH
CLOSED
SWITCH SWITCH
OPEN
SAFETY
V1
W2
3
1
9
7
TO REVERSE
Ridder Control
Ridder Control
Connecting multiple Ridder Controls to
one control source.
Warning: All controllers must have the
same power supply connected in parallel
to L1 and L2.
240V
Power
Supply