Hired-Hand Circulation and Stir Fans: MEGA-FLOW ORIFICE FANS - Manual

HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-0105 Rev. 3-07 Page 1 of 2
MEGA-FLOW ORIFICE FANS
(See Reverse Side for Framing Formats)
1. Fans are intended to be securely mounted by hanging
from a chain or cable but may be installed in a wall.
2. Fan must not be installed within 7 feet of floor or in
reach of personnel or livestock.
FAILURE TO GUARD MOVING PARTS MAY
RESULT IN SERIOUS INJURY OR DEATH.
3. The 52” Fan may be ordered with a post mount kit
option.
4. Connect Power Cord and Electrical Power.
5. Unit is ready for operation.
IMPORTANT! INSPECT FAN FOR ANY OBJECT
THAT MAY OBSTRUCT BLACE ROTATION.
INSTALLATION
MAINTENANCE
1. Read WARNING statements before proceeding.
2. Blades, motor, and wire guards should be cleaned
periodically to decrease vibration and ensure
maximum fan life. Remove dirt with a dry brush or
compressed air.
DO NOT SPRAY MOTOR
WITH WATER OR CLEANING FLUIDS .
3. Fan performance may be greatly reduced by
damaged or dirty shutters. Clean and inspect
shutter periodically to ensure maximum fan
performance.
WARRANTY
Your fan has been manufactured with the finest materials
and components available, and is backed by a one year
warranty against electrical and mechanical defects in
material and workmanship. If this fan fails to operate during
this period, return it prepaid to the place of purchase for
repair or replacement without charge at the manufacture’s
option.
Damage by accident or abuse is not covered by this
warranty.
This warranty gives you specific legal rights and you may
have other rights that vary from state to state.
1. Disconnect power source before installing or
servicing fan. Failure to disconnect power source
can result in property damage, serious injury, or
death.
2. When connected to an automatic controller, FAN
MAY START AT ANY TIME.
3. IMPORTANT! Before Operating Fan, Inspect
Fan For any Object That May Obstruct Blade
Rotation.
4. When this fan is used in a life support ventilation
system where failure could result in loss or injury,
the user should provide adequate backup
ventilation or accept the risk of such loss or injury.
WARNING! !
BEFORE INSTALLING
1. Inspect fan for damage in transit. Check for
loose, missing, or damaged parts.
2. If there are any missing parts or if there is any
shipping damage, do not attempt to operate fan.
Contact your
Distributor.
Do not operate fan until you are completely familiar
with its operation. READ ALL INSTRUCTIONS
PRIOR TO INSTALLATION.
AGRICULTURAL
HEATING
& VENTILATION
SYSTEMS
Total Systems, Total Control