Hired-Hand Light Traps: Light Trap Fan Unassembled - Manual

HIRED-HAND, INC. 1733 Co Rd Bremen, AL 35033 Phone 256-287-1000 Fax 256-287-2000
Manual Part No. 4801-2984
BEARING ASSEMBLY
Rear Bearing Assemblies. Each bearing assembly consists
mounting bracket. Note the different size ends of the Front
2. Assemble the bearing parts exactly as shown in Figure 1
correct, leave 5/16” bolts and nuts loose until shaft is
set screws on each bearing
ATTACHMENT OF VERTICAL MEMBERS
orifice. (Note:
slotted).
member from the bottom. The Left member appears

-

2. Attach the Left and Right vertical members as shown in
ATTACHMENT OF MOTOR MOUNT
2. Attach the motor/motor mount assembly to the vertical members with 3/8” carriage bolts. (Note: Insert
Figure 3. Secure with 3/8” nuts.
Continued On Back
→ →
3. Install the motor pulley. Insert the metal key provided into
Bottom
Left
Vertical
Member
Right
Vertical
Member
Orifice
Top
Slots
(For attachment of
Motor Mount Bolts)
Front Mounting
Bracket
Collars
Bearing
5/16" Bolt
Set Screw
BEARING ASSEMBLY
Rear Mounting Bracket (Sectioned)
Note: Ends Of Front and Rear Mounting
Brackets are different sizes.
Tools Required
8” Standard Wire
Pliers
Rubber Mallet
3/8” Wrench
1/2" Wrench
3/8” Drive Ratchet
3/8” Drive 3” Extension 3/8” Drive 5/32” Allen Head Socket
3/8” Drive 3/32” Allen Head Socket
3/8” Drive Torque Wrench
3/8” Drive - 3/8” Socket
3/8” Drive - 1/2" Socket
3/8” Drive -12 Point Socket
Figure 2
Figure 1
(Unassembled) (Unassembled) ))