IEI Integration RACK-2100G - Manual

RACK-2100G QIG
IEI Technology Corp. Page 1
RACK-2100G / RACK-2100GR
2U Rackmount Chassis
Version: 1.01
Quick Installation Guide
Figure 1: RACK-2100G Front Panel
ABOUT THE RACK-2100G
The 2U, metal RACK-2100G AT/ATX compatible rackmount
industrial chassis is designed to operate reliably in industrial
environments where it will be exposed to dust, wide temperature
variations, shocks and vibrations.
SPECIFICATONS
„ Form Factor: Standard 2U, 19” wide
„ SBC Form Factor: Full-size, PICMG 1.3 slot CPU cards
„ Construction: Metal
„ Slots Number: 6-slot
„ Cooling: 2 x 8cm fans
„ Drive Bays:
o 1 x 5.25” Optical drive bay front accessible
o 1 x 3.5” FDD (floppy disk drive) or HDD (hard disk drive)
bay front accessible
o 1 x 3.5” Internal HDD bay
„ Dimensions (DxWxH):
o 576.9mm x 431mm x 88mm
„ Operating Temperature: 0~40°C
„ Relative Humidity: 5~95%
„ Vibration:
o 5 to 17Hz, 0.1” double amplitude displacement
o 17 to 640Hz, 1.5G acceleration peak to peak
„ Shock: 10G acceleration peak to peak
PACKING LIST
When unpacking the chassis, make sure the following items have
been shipped.
„ 1 x Quick Installation Guide
„ 1 x Power cord
„ 2 x Handles and handle plates
„ 1 x Screw set
„ 1 x PCI/ISA card shock absorber
„ 2 x Keys
„ PSU rear side mounting bracket (RACK-2100GR model only)
DETAILS OF INCLUDED SCREWS
The attached screw set includes five types of screws. Screws used
for chassis installation are shown below.
1 2 3 4 5
Peripherals/Parts
Screw Label
(refer to above picture)
5.25” Disk Drives 5
3.5” FDD 5
3.5” HDD 1
2.5” HDD 4
Power Supply Unit 1
Rackmount Bracket 3
3
Backplane
2
Table 1: Screws for Peripheral/Parts