IEI Integration AFL-W19A_W19B_17D_W15A-N270 v1.06 - Manual (Page 80)

AFL-W19A/W19B/17D/W15A-N270 Panel PC
Page 68
Î
Disabled D EFAULT
Remote access is disabled.
Î
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Flow Control
Redirection after BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
These configuration options are discussed below.
Î Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
Î
COM1 D EFAULT
System is remotely accessed through COM1
Î
COM2
System is remotely accessed through COM2
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Î Base Address, IRQ [2F8h,3]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
Î Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
ƒ 115200 8,n,1 D
EFAULT
ƒ 57600 8,n,1
ƒ 38400 8,n,1