IEI Integration AFL-W19A_W19B_17D_W15A-N270 v1.06 - Manual (Page 33)

AFL-W19A/W19B/17D/W15A-N270 Panel PC
Page 21
Jumper Location: See Figure 2-9
If the AFL-W19A/W19B/17D/W15A-N270 fails to boot due to improper BIOS settings, the
clear CMOS jumper clears the CMOS data and resets the system BIOS information. To do
this, use the jumper cap to close the pins for a few seconds then remove the jumper clip.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
ƒ Enter the correct CMOS setting
ƒ Load Optimal Defaults
ƒ Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 2-5.
Clear CMOS Description
Short 1 - 2 Keep CMOS Setup
Short 2 - 3 Clear CMOS Setup
Table 2-5: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in Figure 2-9 below.
Figure 2-9: Clear CMOS Jumper