IEI Integration AFL-W19A_W19B_17D_W15A-N270 v1.06 - Manual (Page 63)

AFL-W19A/W19B/17D/W15A-N270 Panel PC
Page 51
3.3.2 IDE Configuration
Use the IDE Configuration menu (BIOS Menu 4) to change and/or set the configuration
of the IDE devices installed in the system.
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Power Exit
IDE Configuration
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
ATA/IDE Configuration
[Compatible]
Legacy IDE Channels [SATA Pri, PATA Sec]
Port2 SATA AHCI Speed: GEN 1 (1.5Gb/s)
> Primary IDE Master
: [Not Detected]
> Primary IDE Slave : [ATAPI CDROM]
> Secondary IDE Master : [Not Detected]
> Secondary IDE Slave : [Not Detected]
Options
Disabled
Compatible
Enhanced
ÅÆ Select
Screen
↑ ↓ Select
Item
Enter Go to SubScreen
F1 General
Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
BIOS Menu 4: IDE Configuration
Î ATA/IDE Configuration [Compatible]
Use the ATA/IDE Configuration option to configure the ATA/IDE controller.
Î
Disabled Disables the on-board ATA/IDE controller.
Î
Compatible D EFAULT
The SATA drive is configured on an IDE channel.
Î
Enhanced Both IDE and SATA channels are configured
separately.
Î Legacy IDE Channels [SATA Pri, PATA Sec]
Use the Legacy IDE Channels option to configure SATA devices as normal IDE devices.
Î
SATA Only Only SATA drives are on the IDE channels. IDE drives
are disabled
Î
SATA Pri,
PATA Sec
D EFAULT
SATA drives are configured on the Primary IDE
channel. IDE drives on the Secondary IDE channel