2 ppc-3710 hdd installation, Figure 4-8: ppc-3710 hdd bracket retention screws – IEI Integration PPC-37xx-N270 v2.20 User Manual

Page 48

PPC-37xx-N270 Panel PC

Page 34

Step 5:

Connect the SATA cable from the motherboard to the rear of the HDD.

Step 0:

4.8.2 PPC-3710 HDD Installation

To install the HDD into the PPC-3710, please follow the steps below:

Step 1:

Remove the back cover. See Section 4.5.2 above.

Step 2:

Remove the HDD bracket from the PPC-3710. The HDD bracket is attached on

the PPC-3710 with four retention screws inside the chassis (Figure 4-8).

Remove the four retention screws and lift the bracket off the panel PC.

Figure 4-8: PPC-3710 HDD Bracket Retention Screws

Step 3:

Attach the HDD bracket to the HDD. To do this, align the four retention screw

holes in the HDD bracket with the retention screw holes on the bottom of the

HDD. Insert four retention screws into the HDD bracket. (Figure 4-9).