General Pump MK Repair Manual - Manual (Page 20)

GENERAL PUMP
A member of the Interpump Group
MK SERIES
Page 20
Assemble the bearing on the reducer cover (1, fig. 66).
Assemble the reducer cover (1, fig. 67) and fasten it using 8 M10 x 50 screws (1, fig. 68). Use a
stopper to avoid the bearing coming out of the seat (1, fig. 69).
Calibrate the screws with the torque wrench as indicated in paragraph 3. “SCREW CALIBRATION”
Apply the 3 Ø 12 x 40 pins to the reducer case (1, fig. 64) and insert the gasket (1, fig. 65).