Fulton Pulse HW (PHW) Fully Condensing Hydronic Boiler - Manual (Page 70)

© The Fulton Companies 2013
WARRANTY & PARTS
PHW-IOM-2013-0214
SECTION 5
5-2
Standard Warranty for Fulton Pulse Boilers
Models PHW with Carbon Steel Exhaust Pipes
Ten (10) Year (120 Month) Thermal Shock Warranty
Fulton Heating Solutions guarantees the Pulse hot water pressure vessel against thermal shock for a period of ten (10) years
when the boiler is installed as a closed loop hot water boiler and is operated per the Installation and Operation Manual. This
guarantee will cover damage due to thermal shock, such as leaks in the heat exchanger. This guarantee does not cover damage
due to corrosion, scaling, sooting or improper installation or operation. The inlet and outlet water temperature diff erential across
the boiler cannot exceed 100°F.
Ten (10) Year (120 Month) Prorated Flue Gas Condensate Corrosion and Material and Workmanship Warranty
The pressure vessel is covered against fl ue gas condensate corrosion and defective material or workmanship for a period of
ten (10) years from the date of shipment from the factory according to the schedule below. Fulton will repair or replace F.O.B.
factory any part of the equipment, as defi ned above, provided this equipment has been installed, operated and maintained by
the buyer in accordance with approved practices and recommendations made by Fulton. The commissioning agency must also
successfully complete and return the equipment Installation and Operation Checklists to Fulton’s Quality Assurance department.
This warranty covers any failure caused by defective material or workmanship; however, waterside corrosion or scaling is not
covered. Therefore, it is imperative that the boiler be installed in a closed loop as outlined in the Installation and Operation
Manual.
Year Prorated Schedule
0-7 100%
8 50%
9 30%
10 20%
Parts Warranty
Fulton will repair or replace F.O.B. factory any part of the equipment of our manufacture that is found to be defective in
workmanship or material within 18 months of shipment from the factory or 12 months from start-up (whichever comes fi rst),
provided the equipment has been installed, operated and maintained by the buyer in accordance with approved practices and
recommendations made by both Fulton and the component manufacturers and the commissioning agency has successfully
completed and returned the equipment Installation and Operation Checklists to Fulton’s Quality Assurance Department.
General
Fulton shall be notifi ed in writing as soon as any defect becomes apparent. This warranty does not include freight, handling or
labor charges of any kind. These warranties are contingent upon the proper sizing, installation, operation and maintenance of
the boiler and peripheral components and equipment. Warranties valid only if installed, operated, and maintained as outlined
in the Fulton Installation and Operation Manual. No Sales Manager or other representative of Fulton other than the Quality
Manager or an offi
cer of the company has warranty authority. Fulton will not pay any charges unless they were pre-approved,
in writing, by the Fulton Quality Manager. This warranty is exclusive and in lieu of all other warranties, expressed or implied,
including but not limited to the implied warranties of merchantability and fi tness for a particular purpose. Fulton shall in no
event be liable for any consequential or incidental damages arising in any way, including but not limited to any loss of profi ts or
business, even if the Fulton Companies has been advised of the possibility of such damages. Fulton’s liability shall never exceed
the amount paid for the original equipment found to be defective. Excessive cycling will reduce the life of ANY boiler. Verify that
your system is properly designed and check cycling rate according to maintenance procedures listed in this manual. To activate
the warranty for this product, the appropriate commissioning sheets must be completed and returned to the Fulton Quality
Assurance department for review and approval.
2013-0214