Maintenance, Taking screen shots – Fulton Pulse HW (PHW) Fully Condensing Hydronic Boiler User Manual
Page 67
Questions? Call (315) 298-5121, or visit us online at www.fulton.com
SECTION 4
PHW-IOM-2013-0214
MAINTENANCE
4-7
4
CAUTION
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct, and strict
adherence to applicable jurisdictional/
professional codes and regulations.
All maintenance procedures should
be completed by trained personnel.
Appropriate training and instructions
are available from the Fulton Service
Department at (315) 298-5121 or your local
Fulton Representative.
In order to meet warranty conditions, ensure
all appropriate maintenance activities are
performed.
FIGURE 57 - I/O STATUS DETAIL
Taking Screen Shots
Using the Screen Shot function of the SOLA control can be a useful tool for
troubleshooting. A USB port in the back of the display will accept a small
memory stick or thumb drive for transferring screen shots from the display.
At most locations in the display parameters, there is an icon of a camera in
the upper left of the screen. By pressing this icon, a snapshot of the screen is
captured and saved to the display. To transfer these snapshots to a memory stick
or thumb drive, perform the following:
1. From the Home Screen, press Setup in the lower right hand corner. See
Figure 58.
2. Press Display Diagnostics. See Figure 59.
3. Press Screen Snapshot. See Figure 60. This is the screen from which you
can copy screen shots to a thumb drive.
FIGURE 58 - ACCESSING SETUP