INSTEON Micro Open/Close - 2444-222 (US), 2444-422 (EU), 2444-522 (AUS/NZ) Manual - Manual (Page 14)

Page 14 of 21 2444-222/2444-422/2444-522 - Rev: 2/24/2014 9:10 AM
LED will start blinking red
3) Press and hold Micro module Set button until it double-beeps
Controller LED will stop blinking
4) Test by tapping controller button on and off
Micro module will no longer respond
Remove Micro Module as a Controller of Multiple Responders
1) Press and hold Micro module Set button until it beeps
LED will start blinking green
2) Press and hold Micro module Set button until it beeps again
LED will start blinking red
3) Tap Micro module Set button
LED will start double-blinking red
4) For each responder you are removing:
a. Press and hold Set button until it double-beeps
5) Tap Micro module Set button
Micro module will beep and LED will stop blinking
6) Test by tapping the switch wired into Micro module on and off
None of the former responders will respond
Factory Reset
All settings, links and scenes will be erased.
1) Press and hold Micro module Set button until it beeps
LED will start blinking green
2) Press and hold Micro module Set button until it beeps again
LED will start blinking red
3) Press and hold Micro module Set button until it beeps a third time
LED will start blinking green
4) Slowly tap Micro module Set button 3 times
LED will start double-blinking green
5) Press and hold Micro module Set button. Do not let go.
Micro module will begin to emit a long beep
6) After beep stops, release Micro module Set button
After a few seconds, Micro module will double-beep
X10 Setup
Micro module ships with no X10 address assigned.
Add X10 Address
1) Press and hold Set button until it beeps
LED will start blinking green
2) Send the X10 address 3 times (with or without commands)
Example: A1-AON-A1-AON-A1-AON or A1-A1-A1-AON
Micro module will double-beep and LED will stop blinking
3) Test by sending X10 on and off commands
Load will turn on and off
Remove X10 Address
1) Press and hold Set button until it beeps
LED will start blinking green
2) Press and hold Set button until it beeps again
LED will start blinking red