Biamp LTR - Manual (Page 7)

7
8. Connect to network with Audia software
Open Audia software then connect to network.
File>Network>Connect to network
Close when complete
9. Assign IP address to Audia device
All Audia units ship from the factory with an assigned IP address of
192.168.1.101. When using more than one device in a system, each device
must have a unique IP address. Audia device IP addresses must be different
from any PC IP address that will be used in this system.
File>Network>Perform Audia Device Maintenance>Select desired Audia
device>Set IP address
IP address should be 192.168.1.x (x=1-254)
Subnet mask should be 255.255.255.0
Default gateway should be 0.0.0.0
Click Ok when complete
Close Device Maintenance when complete
Note: To avoid conflict issues that occur when connecting multiple Audia devices
with the same IP number, be sure to only connect one Audia device at a time to
the Ethernet switch when assigning IP addresses.
Repeat steps 6-8 until all Audia devices in system have been connected to
network and assigned a unique IP address.