Biamp LTR User Manual

Page 11

Text mode
Original mode

5. Assign IP address to PC

PC must have a unique IP address before it can communicate with an Audia device.

Right Click My Network>Properties>Local Area Connection>Right Click
Properties>TCP/IP>Properties

IP address should be 192.168.1.x (x=1-254)
Subnet mask should be 255.255.255.0

Click Ok when complete
Close My Network

6. Connect PC to Audia unit

Connect “cross-over” Ethernet cable (supplied with unit) from PC 10/100baseT
Ethernet card to Ethernet jack located on rear panel of Audia unit. “Cross-over”
Ethernet cables have their pins swapped (pin 1 to pin 3, pin 2 to pin 6, pin3 to pin1)
and can easily be identified by looking at the conductors on the RJ-45 connectors. If
the wiring is different at each end, it is a “cross-over” cable.

7. Connect to Audia unit with Audia software

Open Audia software then connect to unit.
File>Network>Connect to network
Close when complete

This manual is related to the following products:

AUDIA