Audia quick start – Biamp LTR User Manual

Page 5

Audia Quick Start

For more complete instructions, see the software Help file or the printable Help
document (on CD).

Connecting to a networked system using Audia with CobraNet

1. Install Audia software on a Windows

XP/7 Professional PC

PC must have a 10/100baseT NIC.

2. Design and Layout system

Launch Audia software. Layout signal flow and DSP as desired. Save layout file
(.dap).

3. Compile Layout

Compile will display number and type of Audia devices required as well as DSP
power used.If compilation cannot find a solution, user intervention may be
necessary. Check for feedback loops, appropriate I/O, appropriate number of
units, appropriate number of CobraNet bundles.

4. Power up Audia devices

Connect supplied power cord to a grounded AC mains voltage of 100-240VAC
@50/60Hz. Connect other end of power cord to power entrance located on the
rear of Audia unit. Note status of front panel LED’s. Under normal conditions, all
LED’s will remain green once power-up sequence has completed.

This manual is related to the following products:

AUDIA