I-View Digi-4800XP 16 channels Hybrid Embedded DVR - Manual (Page 24)

24
Chapter 2. Hardware Installation
After user finish the CPU, RAM and HDD installation, please remember to go to the system Control
Panel to configure the DVR system for installed hardware devices operating properly. For detail about
the setup DVR system configuration in control panel, please refer to chapter 3-1 DVR systems
Control Panel Configuration.
2-1.
Before You Proceed
Take note of the following precaution before you install the components (CPU, HDD and RAM).
1.
Unplug the power cord from the wall socket before touching any component.
2.
Use a grounded wrist strap or touch a safety grounded object or to metal object, such as
the power supply case. Before handing components to avoid damaging them due to
static electricity.
3.
Hold components by the edges to avoid touching the ICs on them.
4.
Whenever you uninstall any components, place it on a grounded antistatic pad or in the
bag that came with the component..
5.
Before you install or remove any component, ensure that the power supply is switched off
or the power cord is detached from the power supply. Failure to do so may cause severe
damage to DVR, peripherals, and/or components.