I-View Digi-4800XP 16 channels Hybrid Embedded DVR - Manual (Page 20)

20
27 keys Remote controller (Optional)
This remote controller special design for the spot monitor application. On your remote controller,
there should be buttons labeled with function button and numbers representing the main
monitor/spot Monitor and camera numbers. Points the remote controller at the sensor/receiver,
press the number of the camera you wish you to on the TV and it would appear.
Number key: For the video channels selections. Simply press the number key from the
“Display” section to display the selected video channel on the connected monitor.
Return (Single video out): To return back to the channels scrolling display mode while in the
signal video display mode.
F1: Press F1 button to assign the video out of Main Monitor 0 to show on the TV.
F2: The Press F2 button to assign the Single TV out (1-16) of DVR to show on the TV.
F3: Press F3 button to assign the video out of Main Monitor 1 to show on the TV.
F4: Press F4 button to assign the Single TV out (17-32) of DVR to show on the TV.
Split Section: Push the splitter key on “ Split ” section, and then you will watch the splitter
video on TV. (Click the ● icon to change 6, 10, 13 split screen sequence).
Return: After you use Display function, then you will return to all channels scroll.
Enter: Press the Enter button to display OSD Menu on the TV.
1
.
When you press the Enter, then F1 button that the control will become to “ 2 MUX + Single
TV Out “Mode. You can control the Single TV and split video output separately, the “ Main
monitor 0 & Spot Monitor 0 “ and “ Main monitor 1 & Spot Monitor 1 “ will synchronize the
video display. The control button as below:
Press F1 button to control the main monitor 0 and spot Monitor 0 display.
Press F2 button to control the Single TV Out (1-16).