ABUS FU9080 Privest Wireless Outdoor Siren - Manual (Page 18)

18
Reading the sounder
After programming the sounder, you have to read it in. You do this by sending a
signal from the sounder to the system. Select one of these functions:
• Press [1] to read in another sounder ID.
• Press [2] to read in the selected sounder. After pressing [2], you have 255
seconds to send a signal from the sounder to the system. To send this signal:
a. Press the reset button on the sounder PCB for ca. 3 seconds.
b. After you release the reset button, you her a short beep and the
external sounder flashes briefly. You now have 10 seconds to press
the tamper contact of the sounder and keep it pressed for at least 3
seconds.
If the sounder is successfully read in, a confirmation signal is emitted.
• Press [3] to delete a sounder from the system.
• Press [4] to select whether the sounder is to be supervised or not.
[9] [2] Parameters
Under Parameters, you program the function characteristic of the sounder.
To access the Parameters menu:
1. In the programming menu, press [9] to access the Siren menu.
2. Press
[2] to access the Parameters menu option.
3. Enter the ID number of the sounder you want to program and press [#].
NOTE:
On internal sounders, you can only adjust the volume.
Parameters
Quick-Key Menu option
[9][2][1] Strobe control
Defines the duration of the visual signal.
[9][2][1][1]
Always off
Visual signalling is deactivated.
[9][2][1][2]
Follow bell
Visual signalling is activated together with audible signalling.
[9][2][1][3]
Follow alarm
Visual signalling is activated on alarm.