XM Satellite Radio XDNX1V1 - Manual (Page 33)

33
5 . Continue with “Step 5: Connect the Magnetic Mount Antenna
and PowerConnect Power Adapter” on page 37 .
• SUV:
1 . Feed the antenna cable underneath the rubber weather
stripping of the rear tailgate window/door and route the cable
along the rear hatch . Lift the weather stripping from the
opening and tuck the cable inside it, then replace the weather
stripping . Pull the cable out from weather stripping and route
it into the cabin under the interior trim . Avoid hinges or gears
that could crimp or cut the cable .
2 . Route the cable through the SUV’s main cabin area under
the interior trim, towards the front of the vehicle . Use a blunt
plastic putty knife or similar blunt tool to lift the plastic trim
just enough to tuck the cable under underneath . Avoid side
airbag locations
on back pillars and
above the doors .
Airbag locations are
marked with “SRS”
logos . Be careful not
to crimp or cut the
cable .
3 . Bring the cable out
from the trim near
the front of the cabin
and route it under