Uniden Data 2000 Wireless CDPD PC Card - Manual (Page 87)

▲ ▲ Uniden Data 2000 Wireless CDPD PC Card
Uniden Data 2000 Installation and Operation Manual D-5
D.3 AT Command Highlights
The tables on the following pages list the AT Commands which are
supported by the Uniden Data 2000 modem. Please note the
following:
● When typing in AT commands, it is recommended, but not
mandatory, that you insert at least one space after typing AT
and between each parameter. Multiple spaces are acceptable.
(The space after the AT is helpful for automated parsing.)
● AT commands are NOT case sensitive.
● In the tables on the following pages, all parameters shown in
[ ] are optional. All parameters shown in < > are required.
● It is unnecessary to login to use AT commands except to save
changes to the MDT or SPDT.
● Any command which requires a modem reset to become
effective is indicated in boldface type.
● This document assumes that the reader has general
CDPD knowledge.
D.4 Login and Logout Procedures
It is necessary to login before saving changes to the SPDT.
● To login, type in the command AT LOGIN, then enter the
SPDT password.
Note: Contact UNIDEN at 1-888-6-UNIDEN to access the SPDT
password. The MDT password is available to Uniden service
personnel only.
● To logout, type in the command AT LOGOUT.