Uniden Data 2000 Wireless CDPD PC Card - Manual (Page 86)

▲ ▲ Uniden Data 2000 Wireless CDPD PC Card
D-4
Note: You can type in the command AT RESETCFG MDT or
AT&F0 followed by the command AT SAVECFG UDT or
AT&W0, at any time, to reset the UDT to the factory default state.
Important: Editing the UDT does not require
a password.
D.2 System Table
The System Table contains specific configuration parameters which are
preserved during the power cycle. Unlike settings in the modem’s
default value tables (MDT, SPDT, UDT), these values cannot be
restored to their original settings once they have been changed.
The following table lists all of the configuration parameters stored in
the System Table:
Settings Default Values
Boot Version Current Version
SW Version Current Version
HW Version Current Version
EID Parameter 12 Hex Characters
NEI1 0.0.0.0
NEI2 0.0.0.0
NEI3 0.0.0.0
NEI4 0.0.0.0
NEI5 0.0.0.0
NEI6 0.0.0.0
NEI7 0.0.0.0
NEI8 0.0.0.0
NEI9 0.0.0.0
NEI10 0.0.0.0
Antenna 2
Flow Control 1
Verbose 1
Echo 1