View or change gpib interface settings, View or change gpib interface settings -10 – National Instruments NI-488.2 User Manual
Page 24

Chapter 2
Measurement & Automation Explorer (Windows)
2-10
ni.com
View or Change GPIB Interface Settings
To view or change your interface settings, complete the following steps:
1.
Start Measurement & Automation Explorer as described in the
Starting Measurement & Automation Explorer
section.
Note
When starting Measurement & Automation Explorer in Windows Vista, you must
choose to run as Adminstrator to allow changes to GPIB Interface Settings. To do this,
right-click on the Measurement & Automation Explorer icon and select Run as
Administrator.
2.
Expand the Devices and Interfaces directory by clicking the + next
to the folder.
3.
Select your GPIB interface in the left window pane of Measurement &
Automation Explorer.
The interface properties appear in the right window pane of
Measurement & Automation Explorer, as shown in Figure 2-5.