NEC PlasmaSync 42PD3 - Manual (Page 35)

P LASMA M ONITOR Ⅵ Ⅵ Ⅵ †
35
Information Screen (DISPLAY MODE)
This permits a check of the signal (data) that is currently being input.
Set [OSD MODE] to [PRO] on the configuration menu, then perform the following operations.
Preparation Press the PROCEED button to display the main menu.
1 Align the cursor with
2
Move the cursor left and right with
the POSITION/CONTROL
ᮤ ᮣ
buttons.
SOURCE INFO.
RGB1
H-FREQ.
V-FREQ.
H-POL.
V-POL.
31.5kHz
60.0Hz
NEG
POS
Press the EXIT button
This removes the menu.
Note:
There is a slight error between the vertical frequency (V-FREQ.) displayed
on the information screen and the actual vertical frequency of the con-
nected input signal.
A +/-3 Hz error exists for signals with a vertical frequency between 60 Hz
and 70 Hz, and a +/-5 Hz error exists for signals with a vertical frequency
above 70 Hz.
Please regard the frequency indications of the information screen in terms
of reference values only.
Information Screen
■ When RGB input is selected
[SOURCE INFO.]:
RGB 1, RGB 2, RGB 3,
DVD/HD
[H-FREQ.] : Horizontal frequency
(kHz)
[V-FREQ.] : Vertical frequency (Hz)
[H-POL.]
: Polarity of horizontal
sync signal
NEG (Negative)
POS (Positive)
[V-POL.] : Polarity of vertical sync
signal
NEG (Negative)
POS (Positive)
■ When VIDEO input is selected
[SOURCE INFO.]
:
VIDEO, SCART
[MODE] : Color system standard
NTSC, PAL, SECAM
SOURCE INFO.
RGB1
H-FREQ.
V-FREQ.
H-POL.
V-POL.
31.5kHz
60.0Hz
NEG
POS
SOURCE INFO.
VIDEO
MODE : NTSC
Note:
[NTSC] is displayed for 4.43 NTSC.
Note:
[NO SIGNAL] is displayed when no signal is present.