Rs-232c, 4) command list – Panasonic AJ-D250P User Manual

Page 41

RS-232C

(4) Command list

List of commands

The table below lists the send commands and operations for each mode as seen from the computer end.

[STX] = HEX code 02H
[ETX] = HEX code 03H

= HEX code 3AH
The discrimination part and data part represent the ASCII codes which support the corresponding
symbols.

Audio control commands

Sends data of computer

Return data from VTR

Description of command

[STX] AOC:m [ETX]

[STX] AOC [ETX]

Sets the audio signal output channel.

Counter control commands

Sends data of computer

Return data from VTR

Description of command

[STX] CCP:data [ETX]

[STX] CCP [ETX]

Presets the CTL counter data (same as CLP).

[STX] CDF [ETX]

Cancels the drop frame mode setting.

[STX] CDN [ETX]

Makes the drop frame mode setting valid.

[STX] CHM:m [ETX]

[STX] CHM [ETX]

Sets 12-/24-hour mode for the CTL display.

[STX] CLP:data [ETX]

[STX] CLP [ETX]

Presets the CTL counter data (same as CCP).

[STX] CRN:m [ETX]

[STX] CRN [ETX]

Sets the signal to be regenerated when TCG is in
regeneration mode.

[STX] CRR [ETX]

Uses the TCG in the REC RUN mode.

[STX] CRT [ETX]

Resets the CTL counter data.

[STX] CTC [ETX]

Sets the mode in which time code data is to be used for the
counter value.

[STX] CTF [ETX]

Uses the TCG in the FREE RUN mode.

[STX] CTL [ETX]

Sets the mode in which CTL data is to be used for the
counter value.

[STX] CTM:m [ETX]

[STX] CTM [ETX]

Sets the TCG operation mode.

[STX] CTP [ETX]

Uses the TCG in the preset mode.

[STX] CTR [ETX]

Uses the TCG in the regeneration mode.

[STX] CTS:data [ETX]

[STX] CTS [ETX]

Presets the TCG data.

[STX] CUS:data [ETX]

[STX] CUS [ETX]

Presets the user’s bit data.

[STX] CVP:data [ETX]

[STX] CVP [ETX]

Specifies the line where the external VITC is to be inserted.