Setup (initial settings) – Panasonic AJ-D250P User Manual
Page 23
Press the MENU-UP button or MENU-DOWN
button to move the cursor (
) to the item
where the changes are to be made.
The page can be scrolled up or down by pressing
the MENU-UP button or MENU-DOWN button
while holding down the MODE button.
4
Press the DATA+ or DATA– button to change
the setting.
The setting value will flash while changes to the
setting are being performed.
5
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
The menu setting procedure is now terminated.
7
Press the SET button to enter the setting.
To change another item, repeat steps
4
,
5
and
6
.
MODE button. To change another item without
entering a setting, press the MODE button, and
repeat steps
4
,
5
and
6
.
6
23
Setup (Initial Settings)
The unit’s main settings can be performed and
checked using the on-screen menus which appear on
the video monitor connected to the unit.
It is also possible to perform and check the settings
using the item numbers and setting numbers which
appear on the front panel’s display.
One user setting memory set is provided with the unit
to enable the desired settings to be stored in the
memory ahead of time for use.
How to perform the settings
using the on-screen menus
Set the LOCAL/MENU/REMOTE switch to the
MENU position.
The unit is now set to the menu setting mode,
and the menu screen appears on the video
monitor.
1
Press the MENU-UP button or MENU-DOWN
button to move the cursor (
) to the menu
where the changes are to be made.
2
Press the SET button to set the item.
To return to the menu screen, press the SET
button while holding down the MODE button.
3
In the menu setting mode, the REW, STOP, FF,
PLAY, PAUSE/STILL and REC buttons serve as
the MODE, MENU-DOWN, MENU-UP, DATA–,
DATA+ and SET buttons.
SET–UP MENU
MAIN
NO.00
00 SYSTEM
000 BASIC
100 OPERATION
200 INTERFACE
400 TAPE PROTECT
500 TIME CODE
600 VIDEO
700 AUDIO
END
How to restore the factory
settings
Set the LOCAL/MENU/REMOTE switch to the
MENU position.
The unit is now set to the menu setting mode,
and the menu screen appears on the video
monitor.
1
Press the RESET button.
The unit is set to the default setting mode, and
the default setting screen appears on the video
monitor.
2
SELECT
MODE
ESCAPE
LOAD
SAVE
PROTECT