Panasonic AJ-D250P - Manual (Page 20)

20
1
Set the unit to the STOP mode.
O
The colon between the seconds and frames changes to a period when a drop frame time
code is read.
O
Interpolation is automatically provided by the CTL signal if the time code signal is missing.
The display appearing at this time will be as shown below.
2
Set to TC or UB using the COUNTER button.
TC: The time code appears on the display.
UB: The user’s bit appears on the display.
O
Interpolation is provided by the CTL signal if the time code cannot be read.
3
Press the PLAY button.
Playback is commenced, and the time code appears on the display.
When ON has been selected as the SUPER setup menu item setting, the time code value
will be superimposed onto the video signals which are output from the MONITOR OUT
connector. (See page 28)
T R 00 : 07 : 04 : 24
“ ” appears here when the time code signal is missing.
(Superimpose only)
The colon between the seconds and frames changes to a
period in the case of a drop frame.
Playing back the time code/user’s bit
Time Codes and User’s Bit