Lennox Hearth JABRA PRO 9470 - Manual (Page 43)

43
english
Jabra PrO 9460, 9460-DuO anD 9470 user manual
StandaRd oPeRation 8.3
During normal operation, the touchscreen shows status information about your headset, displays the current
target phone and indicates its status. from here you can answer an incoming call, end the current call, access
your base settings, choose a target phone and open an audio link to the current target phone.
1. Settings icon: touch here to go to the settings menu for your base
and headset.
2. Battery indicator: indicates the current charge level of your headset.
3. Current target phone: shows the current target phone and
indicates its status (ringing, online, etc.). this is the phone to which
you will connect if you tap the headset multifunction button or
touch the activate-audio-link icon.
4. Other phones: touch the appropriate icon here to change the
current target phone — or press the headset multifunction button
when no call is active to cycle through available phones.
5. Activate audio link: touch here to answer an incoming call or
activate the audio link to the current target phone — or tap the
headset multifunction button when no call is active.
1
3
2
4
5
Figure 33: Touchscreen controls for standard operation
PaiRing and connecting the BaSe and headSet 8.4
to enable secure wireless communication between the Jabra PrO headset and its base, you must pair the two
units. Once paired, they will find, connect and communicate with each other as needed whenever they are in
range and turned on, but they will ignore all other DeCt devices in the area.
Pairing the DECT Base and Headset
the headset can only be paired with one base at a time, while the base is able to pair with one primary
headset and an optional and temporary secondary headset. the secondary pairing enables you to share your
conversation with another headset user to support conference calling (see Section 8.12: Conference Calling). you
cannot pair the Jabra PrO base or headset with other types of DeCt products.
to pair your base and headset:
1. Dock the headset to the charging cradle of the target base.
2. If the headset is not already paired with that base, then the touchscreen will ask you if you would like to do
one of the following:
- Pair as primary: touch this icon to make the current headset the new primary device for the current base.
this will remove any previous primary headset.
- Pair as secondary: touch this icon to make a temporary connection to the current headset. this connection
will only last until the end of the next (or current) call. the current primary headset will be kept and all audio
will be shared with both headsets.
- Do not pair: touch this icon to charge the current headset without pairing with it.
3. touch the icon of your choice and you are done.
Note: a similar pairing mechanism is also used by bluetooth devices. Jabra PrO 9470 supports bluetooth
for the purpose of adding a mobile phone to your headset solution. however, the bluetooth pairing is
completely independent of the DeCt pairing mechanism described above. see Section 9.2: Pairing and
Connecting with Other Bluetooth Devices for details.