Kawai Stage Piano MP5 - Manual (Page 31)

31
When the selected zone is set to EXT, the display shows the MIDI CC numbers.
The default parameters assigned for each knob are as follows.
A: #10 Panpot (PAN)
B: #70 Sustain Level (STN)
C: #76 Vibrato Rate (VbR)
D: #77 Vibrato Depth (VbD)
Note:
If the selected zone is set to BOTH, changing the MIDI CC# parameters affects
both internal and external sections. If you want different settings for internal
and external sections, enter the edit mode by pressing the MENU button and
select internal or external section with the ZONE SELECT button. (See page33
for details.)
Changing MIDI CC parameter
Press and hold the MIDI CC# button. The MIDI CC# button starts blinking and
the cursor in the display moves up to the parameter name.
Use the CONTROL KNOBS to change the parameters.
After changing the parameter, press the MIDI CC# button again. The MIDI
CC# button stops blinking and the cursor in the display moves down to the
value.
Note:
When the selected zone is set to INT, only the following parameters can be
selected.
10 Panpot PAN
70 Sustain Level STN
71 Resonance RSN
76 Vibrato Rate VbR
77 Vibrato Depth VbD
78 Vibrato Delay VbY
93 Chorus Depth ChD
When the selected zone is set to BOTH and the internal section is selected in
edit mode, the parameters not available for INT section show as “ XXX”.