Kompernass KH 2295 - Manual (Page 15)

MON æ Monday
TUE æ Tuesday
WED æ Wednesday
THU æ Thursday
FRI æ Friday
SAT æ Saturday
SUN æ Sunday
ô Note:
To carry out the steps 2 to 7 you have ca. ten
seconds for each step. If one step is delayed,
you must start again from step 2.
2
Press the button “AL1”
2!
again. On the
lower edge of the display
d
the abbrevia-
tions for all seven weekdays are shown.
3
Press the button
i
once. The hour
indicator of the alarm time starts to blink.
4
Programme the hour indicator for the
desired alarm time. To do this, press the
buttons
o
resp.
a
.
5
Press the button
i
again to change to
programming the minute indicator. The
minute indicator for the alarm time starts
to blink.
6
Programme the minute indicator for the
desired alarm time. To do this, press the
buttons
o
resp.
a
.
7
Press the button
i
again to change to
programming the weekday. Blinking in the
display
d
are “ON” and “MON”. Here you
can individually activate or deactivate the
programmed alarm time for all weekdays:
Ú By pressing the buttons
u
resp.
i
you can switch through the weekdays. The
weekday just selected blinks in the display
d
.
Ú By pressing the buttons
o
resp.
a
you can switch between the setting “ON”
and “OFF” for the just selected weekday. The
just selected setting blinks in the display
d
.
With the setting “ON”, the alarm is switched
on to the programmed alarm time on the
selected weekday. With the setting “OFF”,
the alarm is not switched on on the selected
weekday.
Finally you must programme the type of alarm
call required. Three types of alarm call are avail-
able:
Ú Alarm call; radio: At the programmed alarm
time on the selected weekday the radio
switches itself on as the alarm signal.
Thereby, the last radio station it was tuned
to is switched on. The radio remains
switched on for 60 minutes.
Ú Alarm call; alarm-tone: At the programmed
alarm time on the selected weekday the
alarm-tone switches itself on as the alarm sig-
nal. The sound volume of the alarm tone rises
gradually. The alarm tone remains switched
on for ten minutes.
Ú Alarm call; alarm tone and radio: At the
programmed alarm time on the selected
weekday the alarm-tone switches itself on
for ten minutes. The sound volume of the
alarm tone rises gradually. Subsequently,
the radio switches itself on for ten minutes.
Thereby, the last radio station it was tuned
to is switched on.
The currently selected alarm call type is shown
in the display
d
through the following symbols:
Ú resp. for alarm call; RDS radio
alarm
Ú resp. for alarm call; alarm-tone
Ú resp. for alarm call;
alarm tone and radio
To programme the alarm call type:
1 |
 