Kompernass KH 2295 - Manual (Page 12)

With the buttons
o
resp.
a
you can
switch between both display formats.
11
When the desired indicator format is blink-
ing in the display
d
: Wait for ca. 10 sec-
onds, without pressing a button. The dis-
play
d
returns to its normal status; the time
is now shown in the selected display format.
The date is only shown when the radio is
switched off.
8. Using the RDS Radio Alarm
8.1 Using the radio of the RDS Radio
Alarm
The RDS Radio Alarm is fitted with an auto-
matic station scanner with an automatic save
function. The station scanner starts automa-
tically, as soon as the RDS Radio Alarm is con-
nected to mains power. If you would like to use
the station scanner again at a later time:
8.1.1 Using the automatic radio station
scanner
With the radio switched on, hold the button
“Memory”
g
pressed down for ca. three sec-
onds. The automatic station scanner now starts;
Stations with sufficient reception strength are
now automatically saved to fixed programme
positions.
8.1.2 Manually setting and saving radio
stations
If you wish to save other radio stations additio-
nally to the ones automatically saved to fixed
programme positions:
1
Search for a radio station with the buttons
o
resp.
a
. With each press of the
key you will shift the frequency in steps of
50 kHz.
Alternatively, you can also keep the buttons
o
resp.
a
pressed for a short period; this
starts the manual station scanner. If a station is
found with sufficient reception strength, the
station scanner stops.
If a radio station you are searchuing for is being
received, you can save it to one of the 50 fixed
programme positions. Additionally:
ô Note:
To carry out the steps 2 to 4 you have ca. 5 se-
conds for each step. If one step is delayed, you
must start again from step 2.
2
Press the button “Memory”
g
once. In the
display
d
a two-figure programme position
number as well as “GROUP” is shown, the
clock symbol and “MEM” are blinking. To
designate a programme position number for
the tuned radio station:
3
First of all select the number for the first
digit of the programme position number.
For this, repeatedly press the button “Group
WEC”
f
. As soon as the desired figure for
the first digit of the programme position is
shown in the display
d
:
4
Select the figure for the second digit of the
two-figure programme position number.
Repeatedly press the buttons “0/5” to “4/9”.
The buttons have the following functions:
Ú Button “0/5”
;
– for selection of 0 resp.
5 as the second digit of the programme
position
Ú Button “1/6”
l
– for selection of 1 resp.
6 as the second digit of the programme
position
Ú Button “2/7”
k
– for selection of 2 resp.
7 as the second digit of the programme
position
 
| 12