Chapter 4 troubleshooting, Introduction, License reject – StorageTek StorageNet SCSI-3 User Manual
Page 37: Check condition, Invalid field errors, Chapter 4 “troubleshooting, Describes command error messages, Introduction -1, License reject -1, Check condition -1
8946121402
4-1
Chapter 4 Troubleshooting
Introduction
This chapter discusses the
SEND DIAGNOSTIC
command error messages.
License Reject
A license reject is generated when the SES license key is improperly entered or is not
installed.
The following message is generated:
Probable cause:
Invalid Field
Action:
See the
CHECK CONDITION
CHECK CONIDITION
is generated when the SES Device (SESD) terminates an operation
because an error was encountered. These error conditions can be from invalid operations,
warning indications and failure conditions. The sense key and sense code describe the error.
Invalid Field Errors
ILLEGAL REQUEST
is generated from any invalid fields in the CDB, from parameters of a
SEND DIAGNOSTIC
command and from the CDB of a
RECEIVE DIAGNOSTIC RESULTS
command. The sense code identifies the location of the invalid fields, parameter or CDB.
The following message is generated:
Probable cause:
Invalid Field
Action:
See the