Standard Horizon CP500 - Manual (Page 18)

Page 20 CP500
- If Auto Switch is chosen, all the menus will be closed and the video input will be
shown switching between the Video Input Full View (if connected) and the selected
page. See next section for details of setting up the switching times. If the user
agrees to proceed, the image from the video input and the GPS Chart Plotter page
will be shown intermittently. The intermittence time is selected by Switching
Timeout item.
. SWITCHING TIMEOUT, the possible choices are 5,10,30 sec, 1, 5, 10 min. Allows
selecting the timing to change from Video Input and GPS Chart Plotter display.
. RESTORE DEFAULTS, allows restoring the factory defaults for the Input picture
adjustment. When Restore default is executed, the message “OK” is shown next to
the selected menu item.
NOTE
If the video signal is not present on the video connector, the corresponding item in the menu will
be shown in gray and will not be selectable.
b) Quick Activation by pressing [CLR] for 1 second
Pressing and holding [CLR] for 1 second from the Chart page Display or from any main
page (Navigation, Highway, Celestial, GPS Status, DSC, NMEA DISPLAY); the
following Soft Keys are shown: [F
ULL
S
CREEN
], [PIP V
IEW
], [A
UTO
S
WITCH
]. If no video
signal is detected on the Video Input connector, the Soft Keys will be shown in
gray and will not be selectable.
c) Quick Activation by Soft Keys
It is possible to assign the Video Input mode to any of the Soft Keys. Press one of the
Soft Keys, the Soft Keys functions are shown. Pressing and holding for 1 second one
of the Soft Keys, the Soft Keys customization list will be shown. By selecting VIDEO
option it will be possible to assign the Soft Key to execute the Video Input function. Once
the Soft Key has been assigned to Video Input, its label will show the message [V
IDEO
].
If [V
IDEO
] is pressed, the Soft Keys will be assigned this way: [F
ULL
S
CREEN
], [PIP
V
IEW
], [A
UTO
S
WITCH
]. From now on, the functioning is identical to case b).