Installing/replacing seat positioning straps, Installing, Replacing – Invacare Compass SPT PH904A User Manual

Page 51

SECTION 6—BACK/SEAT

Installing/Replacing Seat Positioning Straps

NOTE: For this procedure, refer to FIGURE 6.5.

Installing

1. Remove the hex screw and locknut that secures the back cane to the back plate.

2. Position the seat positioning strap against the back plate.

3. Install the hex screw through the seat positioning strap, coved spacers and back cane.

4. Securely tighten the seat positioning strap to the wheelchair with the locknut.

5. Repeat STEPS 1-4 for opposite side.

Replacing

1. Remove the hex screw, locknut and seat positioning strap from the back plate of the

wheelchair frame.

2. Discard existing seat positioning strap.

3. Install the new seat positioning strap to the wheelchair. Refer to Installing/Replacing

FIGURE 6.5 Installing/Replacing Seat Positioning Straps

Seat Positioning Strap

Hex Screw

Locknut

Back Plate

Back Cane

Coved Spacers

This manual is related to the following products: