Removing, Raising/lowering the elevating legrest – Invacare Compass SPT PH904A User Manual

Page 36

SECTION 4—FRONT RIGGINGS

Removing

1. Push the legrest release handle inward while rotating the elevating legrest outward.

2. Lift the legrest assembly out of the mounting tube of the wheelchair frame.

3. Repeat STEPS 1-2 for opposite side, if necessary.

FIGURE 4.9 Replacing Sector Block

Raising/Lowering the Elevating Legrest

NOTE: For this procedure, refer to FIGURE 4.10.

1. Perform one of the following:

• Raising: Lift legrest assembly up to desired height.

• Lowering: Lift elevating legrest assembly up with one hand. While supporting the

elevating legrest assembly (and user’s leg), pull release lever up with other hand
and lower legrest assembly to desired height.

FIGURE 4.10 Raising/Lowering the Elevating Legrest

Release Handle

NOTE: The mounting tube will be part of the seat frame or wheelchair front frame
depending on wheelchair model.

Mounting Pin

Mounting Tube

Elevating Legrest

Inside of Wheelchair

Release Lever

Elevating Legrest Assembly

This manual is related to the following products: