Features used while on a call, Placing calls on hold, Using call park – Inter-Tel 7000 8662 User Manual
Page 34: Placing calls on hold using call park, Eatures, Hile

20
Inter-Tel
®
Model 8662 Endpoint User Guide
BASIC
FEATURES
F
EATURES
U
SED
W
HILE
ON
A
C
ALL
The following features are primarily used for active or incoming calls.
Placing Calls On Hold
When you place a call on hold, the held party hears music on hold or silence, depend-
ing on your system configuration. While the call is on hold, the system periodically
rings your endpoint as a reminder.
To place a call on hold:
1.
Press
or
the
HOLD
menu button.
2.
Hang up or place another call.
To return to a held call:
1.
Lift the handset or press (handsfree).
2.
Press
or the flashing
button.
If more than one call is on hold, switch between held calls (call hop) by pressing the
flashing
button
assigned to the call.
Using Call Park
Use Call Park to place calls on hold to a designated “orbit” location. After the call is
parked to the orbit location, it can be picked up (answered) by any subscriber.
To use Call Park:
1.
During the call, press
or
the
PARK
menu button.
2.
Enter a 1- to 10-digit orbit number (for example,
), and then press
.
A confirmation notice appears.
3.
Dial the extension number for which the parked call is intended, and then
announce the parked call and the orbit number.
4.
Hang up. You are disconnected from both parties.
If the parked call is not picked up, it will be redirected to the subscriber who parked
the call after the Park Recall timer expires (about two minutes).
To pick up a parked call:
1.
Press
or
the
PKUP
menu button.
2.
Enter the orbit number, and then press
.
LINE
LINE
PARK
1
1
1
#
SUCCESSFULLY
CALL PARKED
PICKUP
#