InFocus MaxFlight MT3000(B) - Manual (Page 81)

Verify that the Maxflight I/O System is listed and enabled just like USB Interface. If not listed
create it and enable it before going on.
5-21E Setup and Calibrating Steering Wheels/Pedals within the
Monster Truck Program.
1. Double click on Device Manager icon then Joystick #1, this opens another window
with several tabs at the top. Must list the following;
a. Direct HAAP UGCI Driving
b. MaxFlight I/O System
2. Select Capabilities Tab: List the following;
a. Maxzilla
b. Maxzilla
2 nd driver
c. Player
3. Select Axes tab;
a. Maxzilla
(1) Steering select Direct Input, select X axis
b. Maxzilla 2 nd driver
Steering select Direct Input, select Y axis
4. Select Axes tab;
a. Maxzilla
(1) Gas Pedal-----Select Direct Input----Throttle
(2) Brake Pedal---Select Direct Input---Check Dig. #1
b. Maxzilla 2 nd driver
(1) Gas Pedal---Select Direct Input---Rudder
(2) Brake Pedal—Select Direct Input---- Check Dig. #3
5. Select Buttons tab;
Maxzilla;
Reverse---Select Direct Input---check Dig. #11
Maxzilla 2 nd driver
Select player 1—select digital input---check dig. #0 check inv.
Select Player 2—select direct input---check dig. #2 check inv.
Player;
Select emergency—select Maxflight I/O—chek dig.
Select DI0
6. Select Devices tab;
Check that it is enabled
Check that device is started
Check there are no error codes listed
Click OK-----DONE, close out all small windows, close out the program window. Test
run the truck on the ground using the small display window to verify you have all
controls working correctly. When you are satisfied all is correct;
Open
Configuration icon again
Double click on 3D Display
Check Full Screen Display
Click OK
Close all the windows and program back to desktop.