InFocus MaxFlight MT3000(B) - Manual (Page 37)

NOTE: When you apply power to the inverters by pulling out the “E-Stop” if there is any motion on
the platform, immediately press “E-Stop” back in. Wait several seconds and try again if “OK” go
to next step.
3.) Pull out “E-Stop” all the legends n the window should highlight and all axes must have the
“START” icons highlighted. If not immediately press on the respective “STOP” icon to
close that axes. Also ensure that the OFF brake icon is highlighted under each axes except
counterweight.
NOTE: All axes movement of the motion platform is monitored by you sitting inside the
machine/cockpit facing forwards.
2-4A Lift Axis
1. To raise the platform, click on the left RAISE icon, the machine will slowly raise to the top.
2. Monitor the current value. As soon as it starts to rise sharply press “STOP” icon.
3. To lower the platform, click on right LOWER icon and the platform will slowly descend.
4. Monitor the current value. As soon as it starts to rise sharply, press “STOP” icon.
NOTE: The platform can be stopped at any point along the lift axis. However, you must not command any
other axes motion unless the platform is all the way at the top.
WARNING: THE PLATFORM MUST BE ALL THE WAY AT THE TOP BEFORE RUNNING
EITHER ROLL OR PITCH MOTION.
2-4B Roll Axis
NOTE!!!! Motion as seen sitting in the machine facing forward.
1. Click on RIGHT icon, the machine will roll clockwise (+) direction, it will continue to roll until you
command “STOP”
2. Hit “STOP” before commanding rotation in opposite direction
3. Click LEFT icon, the machine will roll counter-clockwise (-) until you hit stop.
4.
Hit “STOP” before commanding rotation in opposite direction.
2-4C Pitch Axis
1. Click on left DOWN icon, the machine will PITCH DWN (-) direction, it will continue until you
command “STOP”
2. Click on “STOP”
3. Click on right UP icon, the machine Pitch UP (+) direction.
Hit “STOP” before commanding rotation in opposite direction
2-4D Counterweight Motor
1. Click on DECREASE icon, weight will move towards the center. Hit “STOP” before
going the other way.
2. Click on INCREASE icon, weight will move away from the center.
2-4E Confirm Direction of Motor Movement
The correct direction of motion on the motion platform using the Mitsubishi Inverter control
program buttons is as follows: Direction of rotation is referenced you sitting in cockpit seat.
1. PITCH:
DOWN unit moves (nose-down), UP unit moves (nose-up)
2. ROLL: RIGHT unit moves clockwise, LEFT unit moves counter-clockwise.
3. LIFT: RAISE unit moves upwards, LOWER unit moves down .
4. Counterweight DECREASE moves weight toward weldment, INCREASE moves weight
away from center.