ICP DAS USA IM-100 - Manual (Page 46)

C Acceleration Mode T-Curve、S-Curve、Constant
D Limitation +/- Logic High、Low
E Parameters Start Velocity、Acceleration Velocity、Driving
Velocity、Output Pulse
F Operation Command Servo On/Off、Home*、Forward、Reverse、
Reset、Stop
Read Status Logical Position、Encoder Position、Driving
Speed
G
Home* - user sor for home operation.
When choose ET-M8194H then please input your ET-M8194H IP address
and click ‘Connection’ button for Ethernet connection.
must install limitation sen
¾ When choose ET-M8194H
User can use EzMove utility of ET-M8194H for IP address configuration or
detail function operation. (Please refer the user manual of ET-M8194H).
- 46 -